Orphaned post

Home Forums BulletProof Security Free Orphaned post

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #607

    Setup:  Latest WP w/ multisite enabled
    Followed instructions, installed BPS via the network (did not enable it for the network), then enabled and set it up on the primary site, however when I go through the steps to setup “maintenance mode” and create a form,  all looks fine including viewing the form until I look at the www sites where the main site still has the original theme showing, and the subsites completely lost their templates altogether and all that’s showing are the words that were on the page previously.
    Any suggestions? Should I have installed it directly to the primary site and not the “network?”
    Thanks in advance.

    AITpro Admin

    We just came across this orphaned Post.  A lot of things have changed in BPS in regards to Network/Multisite.


    Maintenance Mode will also go through a major change in BPS .49.9

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.